Simrad Axis 200 Manuel d'instructions télécharger pdf (Page 15)

NOTE - Second level functions are only avail-

able on scanning versions of the 200 and 250.

On non-scanning versions, the F key is re-

placed with a backlighting key.

- Backlighting (F-F)

On scanning models of the 200 and 250, the

LCD display backlighting can be switched on

by pressing F and F again within two seconds.

By keeping F depressed, the radio will step

through the six levels of illumination available

(Fig 2.10). A second press will turn the back-

lighting off.

On non-scanning versions, the backlighting

key – which replaces the F key – must only

be pressed and held once.

While the backlighting is activated, the lamp

legend will be shown on the LCD display.

On all versions, the backlighting will automat-

ically switch off if no button is pressed for ten

seconds or longer. The backlighting will re-illu-

minate if a button is subsequently pressed.

AS - All Channel Scan (F-Channel Down)

This function enables the radio to scan through

each channel sequentially until a signal is

detected which is above the squelch level set.

Once the signal ends or drops below the

squelch level, the radio will continue scanning.

Pressing Channel Up will step to the next

channel regardless of the signal strength.

Pressing Channel Down or F-Channel Down

will exit Scan mode.

M+ - Memory Enter (F-Squelch Up)

This function will add the currently selected

channel into the Scan Memory. The LCD dis-

play will show ‘ENT’ indicating that the chan-

nel has been entered into the Scan Memory.

When that channel is subsequently selected, a

legend will be shown on the bottom line of

the LCD display indicating that the channel is

in the Scan Memory (Fig 2.11). Pressing F-

Squelch Up if the channel is already in the

Scan Memory will remove it from the memory

- indicated by ‘DEL’ appearing on the bottom

line of the LCD display.

D/W

SQ

SQ

16

F

CH

CH

M+

MS

AS

D/W

SQ

SQ

16

F

CH

CH

VOL

VOL

HI LO

M+

MS

AS

F

SIG

Rx

Fig 2.10 - LCD backlighting

D/W

SQ

SQ

16

F

CH

CH

VOL

VOL

M+

MS

AS

D/W

SQ

SQ

16

F

CH

CH

VOL

VOL

M+

MS

AS

Fig 2.11 - Entering channel into Scan Memory

SIG

Rx

F

SIG

Rx

SQ

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Commentaires sur ces manuels

Pas de commentaire