Simrad GC80 Manuel d'instructions télécharger pdf (Page 15)

Simrad DR76, AR78, AR80, AR81 and AR83 Repeaters

10 20221487 / B

3.2 Installation

Panel mounting

1 Drill the mounting holes and make a panel cut-out

according to supplied drilling template

2 Use the supplied screws to fasten the control unit to the

panel

Note Do not over- tighten the mounting screws!

3 Apply the front panel corners

Refer the drawing on page 3 showing the panel mounting for

DR76.

Optional bracket mounting

Numbers in brackets refer to the drawing below.

1 Locate the bracket (1) on the mounting site and mark 5

holes for the fixing screws on the mounting surface

2 Drill the 5 mounting holes and screw the bracket to the

mounting surface

3 Insert the 2 open ratchet disks (2) into the bracket

4 Insert the 2 closed ratchet disks (3) into the repeater

5 Use the locking knobs (4) to assemble the brackets and the

repeater

6 Adjust the repeater to the best viewing angle

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Pas de commentaire

Simrad GC80 Manuel d'instructions Page 15