Simrad Navico WP10 Manuel d'instructions télécharger pdf (Page 15)

Instruction manual

E04596

STBY

NAV

TACK

STBY

AUTO

TACK

NAV

STBY

NAV

TACK

STBY

AUTO

Fig 4.2 - Reducing scaling factor by one

POWER

4 CONFIGURATION

4.1 Scaling

Before using the Wheelpilot, it is necessary to program the

steering sensitivity, which is related to the number of turns

that the wheel makes between end stops. This will determine

the amount of steering correction the Wheelpilot applies.

With the power off, press and hold TACK and NAV, then

switch on the power. Both Port and Starboard LEDs will illu-

minate, the Nav LED will flash, and a repeated sequence of

beeps will be heard. The number of flashes and beeps in the

sequence indicates the current scaling factor (Fig 4.1).

The scaling factor is the total number of half turns from lock to

lock. For example, if the wheel has 1

⁄2 turns from lock to lock,

the scaling factor will be 3.

Press the Starboard ( ) key to increase the scaling factor by

one, to a maximum value of 10 (= 5 turns lock-to-lock). Press

the Port ( ) key to decrease the scaling factor by one, to a min-

imum value of 2 (Fig 4.2) -

Setting

(Beeps/flashes)

Turns lock-

to-lock

⁄2

Fig 4.1 - Scaling factors

To confirm the setting and return to Standby mode, press NAV.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Pas de commentaire

Simrad Navico WP10 Manuel d'instructions Page 15