Simrad PI DEPTH Spécifications télécharger pdf (Page 123)

Sensors

111

857-164636 / Rev.A

Sensor configuration

On delivery, all depth sensors are configured in Channel 16

(300 m), Channel 12 (600 m) or Channel 10 (1000 m) and with

Fast update rate. It is not possible to change the update rate

setting. If you use more than one sensor, you must set them up

to operate in different channels.

Note: The sensor and the PI32 system setup must correspond,

otherwise the communication will not work.

To change the sensor setup (channel selection), use the PI

Configurator utility.

The sensor update rate controls how often the depth is

measured, and the data transmitted to the vessel. To be able to

monitor critical depth information and avoid damage to the

purse seine or the trawl, the depth sensor will only operate on

Fast update rate.

System configuration

Sensor configuration: The sensor must be configured with a

unique sensor number. Select channel number according to the

sensor’s configuration. Write down the configuration for future

reference.

Status & Receiver: The Interference filter must be switched on.

Set it to level 9 if you have noise problems from other

hydroacoustic sources. Note t hat with the filter on, it will

influence the signal spectrum shown in the St atus display.

Sensor filter: Switch this f ilter to Light. Set it to Heavy only if

you experience excessive noise. Position Off will provide raw

data and fastest possible response.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 267 268

Pas de commentaire

Simrad PI DEPTH Spécifications Page 123