Simrad AP25 Manuel d'instructions télécharger pdf (Page 103)

Configuration and setup

20221495F 101

Drive unit voltage

Set the drive unit voltage to correct level. The selections are

12V, 24V, or 32V and should be set to the voltage specified for

your drive unit.

Refer to the drive unit table on page

72 for information.

The drive engage/bypass clutch output follows the same voltage

as set for the drive unit. It is not possible to select a higher

voltage than the input voltage.

Caution ! Selection of improper voltage level for your drive unit may

damage both the drive unit and the autopilot computer even if

the protection circuits in the autopilot computer are activated.

During the Rudder Test, the AP25 system will automatically

detect whether the drive unit is a reversible motor or a solenoid

is operated.

To change the voltage

selection, rotate the course

knob.

Note ! The drive unit voltage setting does not apply when operating

solenoids on a continuous running pump/steering gear. Hence,

the output voltage to the solenoids will be the same as the input

voltage.

Proceed to next menu item by pressing STBD button.

Rudder Feedback Calibration

Make sure the RF300 is installed and aligned as pr. instruction in

section

3.6 (or eventually section 3.27 for LF3000). This

function enables you to compensate for any non-linearity in the

transmission between the rudder and the rudder feedback.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 171 172

Pas de commentaire

Simrad AP25 Manuel d'instructions Page 103