Simrad AP25 Manuel d'instructions télécharger pdf (Page 111)

Configuration and setup

20221495F 109

Dockside settings when configured for

Virtual Feedback

The Virtual Feedback algorithms in the autopilot software enable

your autopilot to steer without having to mount a conventional

rudder feedback unit. These algorithms are designed for vessels

up to 40 ft. powered by outboard or stern drives only.

Installing a feedback unit, however, will always enhance the

performance of an autopilot and provide an accurate rudder

angle indicator on the autopilot display. Unless impractical or

impossible, a rudder feedback unit should be installed.

Note ! The autopilot is automatically configured for Virtual Feedback

when there is no feedback unit connected at first time turn on, or

at turn on after a Master Reset has been performed (Page

132).

At first time turn on the autopilot

will after approx. 5 seconds sound

and display a feedback failure

alarm. Press the STBY button to

silence the alarm and follow the

instructions in the display to initiate

the Setup as described on page

95.

Press and hold the INFO/SETUP

button to enter the Installation setup

menu. Select “Dockside” and turn

the course knob clockwise to open

the “Dockside” menu. This will

automatically configure the

autopilot for Virtual Feedback, and

the alternating feedback alarm will

disappear from the display.

When the autopilot is configured

for Virtual Feedback the Boat type

is automatically set to Outboard.

The (autopilot) Drive unit voltage

should be set to the voltage

specified for your drive unit. See

page

101.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 171 172

Pas de commentaire

Simrad AP25 Manuel d'instructions Page 111