Simrad AP25 Manuel d'instructions télécharger pdf (Page 15)

System description

20221495F 13

1.8 Optional equipment

A series of optional equipment are available for the basic AP25

system.

R3000X Remote Control

A small handheld remote control with two push buttons for

power steering or course selection (port and starboard), and one

push button with built-in lighted indicator for limited mode

change.

JS10 Joystick

The JS10 Joystick is a Non-Follow-Up steering lever designed

for indoor and outdoor console mount. It has a spring-loaded

return-to-mid-position feature and is equipped with 10 m (33’) of

cable and installation hardware.

FU25 Follow-Up Steering Lever

Note ! Not applicable for Virtual feedback configuration (page 66).

The FU25 Follow-up steering lever features a dial with 5° rudder

angle markings. The rudder will move and stop at the angle

selected on the dial. The FU25 has a mid-position indent, buttons

for (limited) mode selection, and mode indicators. It is designed

for indoor and outdoor bulkhead or flush panel-mounting.

Refer to the FU25 manual for more information.

TI25 Thruster Interface

The TI25 Thruster Interface is designed to provide a control

signal for operating a thruster interfaced to an AP25 system. It

operates on/off solenoids, or a Danfoss PVEM valve. The

Danfoss valve is a proportional valve that will provide full

thruster performance with the output from TI25. The thruster

output signal is calculated in the TI25 based on the mode of

operation and the heading information. Set-up is from the control

unit communicated via Robnet2. All settings are stored in the

thruster interface unit.

Refer to the TI25 manual.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 171 172

Pas de commentaire

Simrad AP25 Manuel d'instructions Page 15